Points to Note When Using AAG Compressed Air Dryers

• Read the operation instructions carefully before using your device.
• Do not let any person other than the authorized service personnel open the outer casing of your device. There is a pressurized chamber inside. Can pop out during mounting dismounting and cause work accidents. If you have to open you must first discharge this compressed air. For this discharging  close the valves no "3 and 14 and open the manual valve under filters no 11 and 8 or the automatic discharge valve and start of he dismounting or mounting for service after you make sure the compressed air inside is completely discharged.
• Use your device on a firm and flat surface.
• Ensure that the voltage at the site of use of the device is the same as the voltage level specified on  the label of your device.
• Do not keep or use your device near combustible or flammable materials such as store, under racks etc.
• Do not keep or use your device  in dusty, rusty or moist places.
• Do not use any metal tools or equipment and abrasive cleaners (chemicals) to clean your device. You may damage your device.
• Do not immerse your device or its cable in water. You can wipe with a dry cloth.
• When unplugging your device from the socket do not pull from the cable
• Use your device always in an earthed socket
• Take care that the power cable of your device does not contact hot surfaces
• If your cable is damaged or the device is out of order do not use it. Contact authorized service.
• Use the cable of your device fully unwounded
• Do not drop the device during moving or transportation, avoid hard blows
• Use an air filter on the installation before and after the air dryer that is according to the operation pressure and flow
• Do not place a load in excess of 10 kg on your device
• Strictly avoid contact with liquids
• Do not operate in hot environment (ambient temperature max.25 C° ~ 35 C°)
• Clean the condenser of your device with compressed air once a week
• Set value +3 C° (dewing point)
• It is not recommended that the device is used by any person other than the person in charge of the device

• Take your device out of the box carefully
• Check for any assembly or transportation errors
• Place your device on a firm surface taking care for safety warnings
• Check for leaks in the air installation your device will be used in

• Insert the plug in the socket
• Bring the air installation to open position
• Bring the on/off switch to "on"

 

• Do not operate your device in voltages specified under technical specifications
• Do not use at a pressure above its capacity (Pmax.=13 bar), and flow (IDEAL DRYER RATED FLOW), at ambient temperature (tmax.=40°C)and at compressed air input temperature (tmax.=45°C). In this case  THE IDEAL DRYER RATED FLOW formula should be used. Contact your seller.
• In situations where the ambient temperature and the air input temperature are high the intermediate cooler shown with number 3 in the layout plan and the water separator shown with number 4 should be added to the system.
• Do not use outdoors
• Do not interfere with the digital indicator settings as not to spoil the settings. (If you have to set your device, you will see the set value when you push the SET button without releasing. To change this value keep your finger on the SET button and raise or lower the SET value with arrow ▼▲ buttons.
• If there is a by-pass line on the installation your device is connected to bring it to closed position
• If there are any problems with the electrical installation your device is connected to do not operate your device